Most of these runners are bound on the landing about 3" in from the wall, which should line up with the edge of the runner going up the second part of the staircase. Although this is a very attractive look, keep in mind that the pressure on the seam from foot traffic will cause the runner to become worn or even pull apart over time.Īnother more popular and practical choice would be to run the runner up and over the landing, and then start a new runner on the first riser of the second part of the stairs. This means the runner is seemed together as one continuous piece, like the corner of a picture frame. One option is to have the runner mitered. If you have a 90 degree turn with a flat landing, you will need to decide how you want the runner to look. How to Measure Stair Runners With 90 Degree Turns The runner is installed starting at the base of the first riser, and continues up the stairs to end just under the nose of the landing on the second floor. Divide that number by 12 to convert into feet, then add 8" for each additional riser.įor standard straight stairs, a 21' cut roll runner will usually suffice. Take the total number of complete steps (riser + tread) and multiply by 19". For example 5 steps, then a landing, then another 6 steps, If your stairs take a 90 degree turn, with a landing in the middle, you will add two additional risers- one leading up to each landing. All stairs have one more riser than tread, which leads to the top landing. Most risers are about 8" and treads are approximately 10", therefore we suggest you figure about 19" per stair. Stairs consist of two parts: Risers (vertical part) and Treads (horizontal part) The total can be adjusted when you access the shopping cart page. To order, simply add the number of linear feet you will need to the cart. If you are installing the stair runner yourself, or having it installed professionally, we at Rugs Done Right are happy to help you every step of the way, we also have a blog about how to How to Fit Striped Carpets for Hall Stairs and Landings, click on it to get more information! They should be able to provide a free estimate and tell you how many linear feet you will need. If you have a curved staircase, you will need to have the runner installed by a professional stair runner installer. This created a unified look, but the runner needs to be seamed on the landing by a professional installer, and the seam may show after some time due to the stress. Another option is to have the runner mitered on the landing. The second runner starts at the base of the second set of steps and continues to just under the nose of the upstairs landing. One runner goes up the first part of the stairs and over the flat landing, ending just before the wall. Most often people use two runners on these types of staircases. If you have a staircase that takes a 90 degree turn, but has a flat landing, you will need to decide how to lay the runner. We recommend adding one extra foot of runner length to your total, just to be safe.
0 Comments
Leave a Reply. |